BROADCOM BCM5705M DRIVER
|Date Added:||4 April 2018|
|File Size:||26.1 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
I had the same problem the packages broadcoom installed successfully but the card didn’t work. Everything worked fine after I’ve installed bfwcutter and firmware-b43legacy-installer.
This works without any additional drivers. I would perhaps re install your drivers which should not take long Do this via a terminal and you should see if anything goes wrong So in a terminal type the following sudo apt-get remove bfwcutter firmware-binstaller then sudo apt-get install bfwcutter firmware-binstaller This should reinstall your wifi driver Alternatively what I have done is install the other broadcom proprietry driver STA This was just as easy again via the terminal Clear out any older files sudo apt-get remove bcmwl-kernel-source sudo apt-get install bcmwl-kernel-source If you are still being prompted for entering your password make sure that you have enabled your pc to remember the password.
KEMP LoadMaster – Bare Metal Hardware Compatibility list
After trying several times to install the firmware-b43legacy-installer I found an Intel card and replaced it. The following got my card working:.
I’ve done a fresh install of Natty This question has been asked before and already has broadcoj answer. Tried these out but still no luck. See first answer in this question: I have an older Gateway laptop with a Broadcom card.
How do you get the Broadcom BCM wireless card working? – Ask Ubuntu
I have a Broadcom BCM wireless network card and it failed to come up. After a bit of reading, I installed the bfwcutter and the firmware-binstaller. I had this same problem on a Dell Latitude D The boradcom got my card working: It said no drivers installed. How do you get the Broadcom BCM wireless card working? Was you connected to network when you installed firmware-binstalleror just get the. My first try was firmware-binstaller but after configuration a the installer sent a message saying that an unsupported B43 device was found.
Not sure how to report this issue, but I think it’s a problem with the firmware installer package.
If you are still being prompted for entering your password make sure that you have broadckm your pc to remember the password. It turned out it had been blacklisted.
Now it will attempt to connect to the wireless network and asks for the WPA2 password. Home Questions Tags Users Unanswered.